To program the Garage Door Repair Keller TX opener in a Lexus ES350, follow these step-by-step instructions:

  1. Before you begin, ensure that your garage door opener is compatible with the HomeLink system used in the Lexus ES350. Most garage door openers manufactured after 1996 are compatible, but it’s always best to check your owner’s manual or contact the manufacturer to confirm.
  2. Locate the HomeLink buttons in your Lexus ES350. They are usually located on the ceiling console, above the rearview mirror, or on the driver’s sun visor. You will find three buttons, labeled “HomeLink” or with an icon that resembles a house.
  3. Clear any existing programming in the HomeLink system. Hold down the first and third buttons simultaneously until the indicator light starts blinking rapidly. This usually takes about 20 seconds. Release the buttons when the light starts blinking.
  4. Get your garage door opener remote control ready. You will need it to complete the programming process.
  5. Hold your garage door opener remote control close to the HomeLink buttons in your Lexus ES350, within a few inches.
  6. Press and hold the button on your garage door opener remote control that you want to program to the Lexus. At the same time, press and hold the corresponding HomeLink button in your Lexus. Keep both buttons pressed until the HomeLink indicator light starts flashing slowly. This usually takes about 20 seconds.
  7. Release both buttons when the HomeLink light starts flashing slowly. This indicates that the programming was successful.
  8. Now, go to your garage door opener motor unit, usually mounted on the ceiling in your garage. Locate the “Learn” or “Program” button on the motor unit.
  9. Press the “Learn” or “Program” button on the motor unit. You will have about 30 seconds to complete the next step.
  10. Go back to your Lexus ES350 and press and hold the programmed HomeLink button that you want to use to operate your garage door. Hold it down until the garage door starts moving or the indicator light on the motor unit flashes, indicating that the programming is complete. This process may take a few seconds.
  11. Test the programmed HomeLink button by pressing it once. The garage door should open or close accordingly. If it doesn’t, repeat the programming process from step 4.
  12. Once the programming is successful, you can program additional HomeLink buttons for other garage door openers or devices, following the same steps.

Note: Some garage door openers require an additional step to sync with the HomeLink system. Consult your garage door opener’s manual for any specific instructions.

Remember, these instructions may vary slightly depending on the model year of your Lexus ES350 and the Garage Door Repair Keller TX opener you are using. Always refer to your vehicle’s owner’s manual for precise instructions or contact the manufacturer for further assistance.

Keller Garage & Overhead Doors

3529 Heritage Trace Pkwy#12, Keller, TX 76244

817-769-3540