Programming your garage door opener is a fairly simple process that can be done by yourself. Whether you’re setting up a new opener or reprogramming an existing one, the steps are similar.

Here are the steps I took to program my garage door opener as stated in Redlands Garage Door:

  1. I started by reading the owner’s manual for my garage door opener to make sure I understood the specific instructions for my model.
  2. Next, I located the learn button on the motor unit of the opener. It was a small button that was easy to find.
  3. I cleared out any previous codes by pressing and holding the learn button until the light on the opener blinked.
  4. I chose a four-digit code for my garage door opener.
  5. To enter the code, I pressed the learn button on the opener and then entered the four-digit code on my remote control.
  6. After entering the code, I tested the garage door to make sure it opened and closed properly.
  7. I then programmed additional remotes by pressing and holding the learn button on the opener and then pressing the button on the remote.
  8. Finally, I programmed my garage door opener with HomeLink by pressing and holding the HomeLink button until the light on the system blinked and then programming the code using the steps outlined in the manual.

Throughout the process and by following Redlands Garage Door, I made sure to keep the owner’s manual handy for reference and to reset the opener by unplugging it from the power source if I encountered any issues. Overall, programming my garage door opener was a fairly simple process that I was able to complete on my own.

Redlands Garage Door & Gates

1255 Devon Pl #7, Redlands, CA 92374, United States

909-675-1732