Replacing a Garage Door Repair Suwanee GA is a task that requires careful attention to safety and precision.
Torsion springs are under high tension and can be dangerous, so it’s crucial to follow the steps below with caution. If you’re not comfortable with this process, it’s highly recommended to seek professional assistance.
: Safety First
Before starting any work, ensure your safety. Wear protective gear, including safety glasses and gloves. Make sure the garage door is closed and disconnected from the opener to prevent accidental movement.
: Identify the Type and Size of the Torsion Spring
Determine the type and size of the torsion spring you need to replace. This information is usually found on the existing spring or in the garage door manual. Purchase a replacement spring that matches these specifications.
: Gather Necessary Tools and Materials
You’ll need a winding bar, vise grips, a wrench set, a ladder, and a replacement torsion spring. Ensure you have the correct tools for your specific garage door model.
: Release Tension from the Old Spring
Using a winding bar, insert it into one of the winding cone holes on the old spring. With a second winding bar, apply force in the opposite direction to release tension. Do this for both springs if your door has two.
: Disconnect the Old Spring
Once the tension is released, use vise grips to secure the spring on the shaft. Use a wrench to loosen the set screws on the winding cone. Slide the old spring off the shaft.
: Install the New Torsion Spring
Slide the new torsion spring onto the shaft. Ensure it is centered and secured with vise grips. Tighten the set screws on the winding cone using a wrench. Be cautious not to overtighten.
: Wind the New Spring
Using the winding bars, wind the new spring by inserting the bars into the winding cone holes. Follow the manufacturer’s recommendations for the number of turns required based on the weight of your garage door.
: Test the Torsion Spring
Once the new spring is wound, carefully remove the winding bars. Test the tension by slowly opening the garage door. If the door stays in place when partially open, the tension is correct.
: Repeat for the Second Spring (if applicable)
If your garage door has two torsion springs, repeat the above steps for the second spring.
: Reconnect the Garage Door to the Opener
Reconnect the garage door to the opener by pulling the release cord. Operate the door manually to ensure it moves smoothly and evenly.
: Lubricate Moving Parts
Apply lubricant to the moving parts of the garage door, including the springs, rollers, and hinges, to ensure smooth operation.
: Conduct a Final Safety Check
Test the garage door multiple times to ensure it operates smoothly. Listen for any unusual sounds and visually inspect the springs and cables for proper alignment.
: Dispose of Old Springs Safely
Dispose of the old torsion springs according to local regulations. Do not attempt to reuse or repair a damaged spring.
: Seek Professional Help if Needed
If you encounter difficulties or feel unsure at any point during the process, it’s crucial to seek professional assistance. Torsion springs are under high tension and mishandling can lead to serious injuries.
Remember, safety is paramount when dealing with Garage Door Repair Suwanee GA. If you’re not comfortable or experienced with this task, it’s best to hire a professional garage door technician to handle the replacement of torsion springs.
Southern Home Creations Garage Doors & Openers
4110 Tench Rd Suite D, Suwanee, GA 30024, United States
1-770-831-0301