I can provide information on how to reprogram a Sears Craftsman garage door opener based from Garage Door Repair Encino CA.

  1. Locate the learn button: The learn button is usually located on the garage door opener motor or the control panel. Check your garage door opener’s manual to find the exact location of the learn button.
  2. Clear the memory: Press and hold the learn button until the indicator light beside it turns off. This will clear the memory of the garage door opener.
  3. Enter programming mode: Press and release the learn button. The indicator light will turn on, indicating that the garage door opener is in programming mode.
  4. Program the remote: Press and hold the button on the remote that you want to program. Release the button once the indicator light on the garage door opener blinks. This indicates that the remote has been programmed successfully.
  5. Test the remote: Test the remote to ensure that it works properly. Press the button on the remote and the garage door should open or close.
  6. Repeat the process for other remotes: If you have multiple remotes that you want to program, repeat the above steps for each remote.

As per Garage Door Repair Encino CA, note that these steps may differ slightly depending on the specific model of your Sears Craftsman garage door opener. It’s always best to refer to your garage door opener’s manual for specific instructions.

Sepulveda Garage & Overhead Doors

16650 Ventura Blvd #6, Encino, CA 91436, United States

818-369-3937