When I was installing my garage door, I followed these steps that I got from Garage Door Repair Carmichael CA:

  1. I gathered all the necessary materials and tools required for the installation process, including the garage door panels, tracks, springs, hinges, rollers, cables, brackets, screws, bolts, and a power drill.
  2. I measured the width and height of the garage opening and ensured that it was square. I removed any old garage door hardware and cleaned the area where the new door was to be installed.
  3. I began by installing the bottom panel of the garage door. I followed the manufacturer’s instructions for attaching hinges, rollers, and brackets.
  4. I installed the vertical and horizontal tracks on either side of the door opening. I made sure they were level and secured them to the wall with brackets.
  5. With the bottom panel and tracks in place, I installed the remaining panels one at a time. I attached hinges and rollers as I went along.
  6. I then installed the torsion spring above the door opening, following the manufacturer’s instructions. I made sure to use caution when working with the spring, as it is under tension and can be dangerous.
  7. Next, I installed the lifting cables and pulleys, making sure they were properly attached to the door panels and the spring.
  8. I tested the door to ensure it opened and closed smoothly and without any issues. I made any necessary adjustments to the spring tension, tracks, or cables as needed.
  9. Lastly, I installed the garage door opener according to the manufacturer’s instructions after the door was installed and tested.

Overall, as stated in Garage Door Repair Carmichael CA, it’s important to note that installing a garage door can be a complex and dangerous task, and it may be best to consult a professional if you are not experienced with garage door installation.

LMS Garage Door Repair Carmichael

4751 Manzanita Ave, Carmichael, CA 95608, United States

916-866-7527