First, it’s important to understand that garage door springs can be very dangerous, especially if they’re broken. They’re under a lot of tension, and if they’re not handled properly, they can cause serious injury or even death. So, it’s best to proceed with caution and if you’re not confident, it’s better to call a professional for help.

That said, if you’re comfortable working with tools and have some experience with garage doors, you may be able to fix broken springs yourself.

Here are the steps that I followed from Cleveland Garage Door:

  1. Determine the type of springs you have. There are two main types of garage door springs: torsion springs and extension springs. Torsion springs are located above the door, while extension springs are located on either side of the door. They have different mechanisms and require different tools to fix, so it’s important to know which type you have before proceeding.
  2. Get the right tools. For torsion springs, you’ll need a winding bar, a socket wrench, and a ladder. For extension springs, you’ll need pliers, a vise grip, and a ladder.
  3. Release the tension. This is the most important step and it’s crucial to do it safely. For torsion springs, use the winding bar to loosen the tension by turning the spring in the opposite direction of the winding cone. For extension springs, use the pliers to remove the safety cable and then release the tension by pulling on the cable and moving it to the next hole.
  4. Remove the old springs. Once the tension is released, you can safely remove the old springs. For torsion springs, use the socket wrench to loosen the set screws and then slide the spring off the shaft. For extension springs, use the vise grip to hold the spring and then remove the safety cable.
  5. Install the new springs. This is the tricky part and it requires some precision. For torsion springs, slide the new spring onto the shaft and then tighten the set screws. Use the winding bar to wind the spring and create tension. For extension springs, thread the safety cable through the spring and then attach it to the safety bracket.
  6. Test the door. Once the new springs are installed, it’s important to test the door to make sure it’s balanced and functioning properly. Open and close the door a few times and observe its movement. Adjust the tension as needed until the door is balanced.
  7. Call a professional if needed. If you’re not confident in your ability to fix broken springs or if you encounter any problems during the process, it’s best to call a professional for help. Garage door springs can be very dangerous and it’s better to be safe than sorry.

In summary, based from Cleveland Garage Door, fixing broken springs in your garage door can be a challenging and potentially dangerous task. However, with the right tools and knowledge, it’s possible to do it yourself. If you’re not confident in your abilities or if you encounter any problems, don’t hesitate to call a professional for help.

Cleveland Garage Door Repair

3377 Euclid Heights Blvd, Cleveland, OH 44118, United States

216-714-1631