To change the code for your garage door opener, follow these steps from Garage Door Repair:

  1. Locate the Programming Button: The programming button is usually found on the back or side of the motor unit for garage door openers with a keypad outside the garage. If you have a control panel inside the garage, look for the programming button on the back or side of the panel.
  2. Clear the Existing Code: Press and hold the programming button until the indicator light on the opener starts flashing. This usually takes about 10 seconds. The indicator light may be located on the motor unit or on the control panel, depending on the type of opener you have.
  3. Enter the New Code: Once the existing code is cleared, it’s time to enter the new code. For keypad-operated openers, press the “Learn” or “Program” button on the motor unit, then enter your desired code on the keypad. Some models may require you to press the “Learn” or “Program” button again after entering the code to confirm it.

If you have a control panel inside the garage, press the programming button and then enter the new code on the control panel keypad. Again, some models may require an additional step to confirm the new code.

  1. Test the New Code: After setting the new code, it’s important to test it to ensure it works properly. Close the garage door completely, wait for a few seconds, and then enter the new code on the keypad or control panel. The garage door should open smoothly. Repeat the process to close the door and confirm that the code is functioning correctly.
  2. Sync Remote Controls: If you have remote controls for your garage door opener, you’ll need to sync them with the new code. To do this, locate the “Learn” or “Program” button on the motor unit or control panel, press it, and then press the button on your remote control. The indicator light on the opener should flash to indicate successful syncing. Repeat this process for each remote control you have.
  3. Document the New Code: It’s important to keep a record of the new code in a safe place. Write it down or store it digitally in a secure manner so you can easily refer to it if needed.

Remember, these steps are general guidelines, and the specific instructions may vary depending on your garage door opener’s manufacturer and model. Consult the instruction manual provided by the manufacturer for detailed, model-specific instructions.

Overall, based from Garage Door Repair, if you encounter any difficulties or are unsure about the process, it’s recommended to seek assistance from a professional garage door technician. They have the expertise to guide you through the code change process and address any issues that may arise.

I hope this helps you successfully change the code for your garage door opener!

CCM Overhead Doors

1000 NW 80th St, Oklahoma City, OK 73114, United States

405-563-8982