When I first purchased my Genie garage door opener, I needed to program it to work with my remote control.

Here’s a step-by-step account of how I accomplished it according to Garage Door Repair Services:

  1. I made sure that the remote control had fresh batteries. This ensured a strong signal during the programming process.
  2. To begin programming, I located the “Learn” button on the Genie garage door opener. In my case, it was located on the side of the motor unit.
  3. I pressed and held the “Learn” button until the LED light on the opener turned off or started blinking. Releasing the button cleared the memory of the opener, preparing it for programming.
  4. After clearing the memory, I pressed the “Learn” button once. This caused the LED light on the opener to start blinking or remain steady, indicating that it was ready for programming.
  5. Within 30 seconds of pressing the “Learn” button, I pressed the button on the remote control that I wanted to program. As I did this, I noticed that the LED light on the opener flashed or briefly turned off, indicating that the programming was successful.
  6. To ensure that the programming was successful, I tested the remote control by pressing the programmed button. I observed the garage door responding by either opening or closing.
  7. If I had additional remote controls to program, I repeated the previous step within the 30-second time frame. Each time, I pressed the “Learn” button on the opener and then the button on the remote control I wanted to program. The LED light on the opener confirmed each successful programming.
  8. I also had the option to program a wireless keypad if my Genie garage door opener had one. To do this, I followed the instructions provided by Genie, which involved locating the “Program” or “Learn” button on the opener, entering a desired PIN code on the wireless keypad, and confirming the programming.
  9. Once I had finished programming all the remotes and optional accessories, I pressed the “Learn” button on the opener one more time. This action turned off the LED light or stopped it from blinking, indicating that the programming mode was completed.

It’s important to note that these steps are based on my personal experience, and they may vary depending on the specific model of your Genie garage door opener. I would recommend referring to the user manual provided with your opener or visiting Genie’s official website for accurate and detailed programming instructions tailored to your particular model.

By following the programming steps from Garage Door Repair Services and using the appropriate resources, you should be able to successfully program your Genie garage door opener, allowing you to conveniently operate your garage door using the remote control and any optional accessories.

Arnold’s Garage Door Service

2129 Tippy Ter, Fort Worth, TX 76134

682-261-6268