Garage Door Repair Rockwall TX This process may be necessary if you’ve lost a remote control or keypad, or if you want to reset the opener to its factory settings.

Here’s a detailed guide on how to erase a Genie garage door opener:

1. Locate the “Learn” Button:

  • Begin by locating the “Learn” button on your Genie garage door opener. This button is typically found on the motor unit of the opener, near the antenna wire. It may be labeled as “Learn,” “Smart,” or “Program.”

2. Prepare the Opener:

  • Ensure that the garage door is closed and that there are no obstructions in the door’s path. This prevents accidents and ensures a smooth erasing process.

3. Access the “Learn” Button:

  • If the “Learn” button is located on the motor unit itself, you may need to use a step stool or ladder to reach it. Make sure you can comfortably access the button before proceeding.

4. Press and Hold the “Learn” Button:

  • Press and hold down the “Learn” button on the garage door opener motor unit. Hold the button down until you see a light or indicator on the motor unit turn on or flash, usually within 10-15 seconds. This indicates that the opener is in programming mode.

5. Release the “Learn” Button:

  • Once the light or indicator is activated, release the “Learn” button. The opener is now ready to erase all programmed remote controls and wireless keypad codes from its memory.

6. Erase Remote Controls:

  • To erase remote controls, press and hold the button on the remote control that you want to erase. Hold the button down until you see the light or indicator on the opener motor unit flash, usually within 10 seconds. Repeat this step for each remote control you want to erase.

7. Erase Wireless Keypad Codes:

  • If you have a wireless keypad, you can erase its codes by entering a specific sequence of numbers on the keypad. Refer to your Genie garage door opener’s instruction manual for the correct sequence, as it may vary depending on the model.

8. Verify Erasure:

  • Once you’ve erased all remote controls and wireless keypad codes, test the opener to ensure that none of the previously programmed devices can operate the garage door. If successful, the opener’s memory has been cleared.

9. Reset Factory Settings (Optional):

  • If you want to reset the opener to its factory settings, you can perform a complete reset after erasing the remote controls and keypad codes. Refer to your Genie opener’s instruction manual for specific reset instructions, as the process may vary by model.

10. Program New Remote Controls or Keypad Codes:

  • After erasing the old codes, you can now program new remote controls or wireless keypad codes into the opener’s memory following the manufacturer’s instructions.

Conclusion:

  • Garage Door Repair Rockwall TX This process helps maintain security and control over access to your garage. If you encounter any difficulties, refer to your opener’s instruction manual or contact Genie customer support for assistance.

BH Garage Doors and Gates

4035 N Goliad St, Rockwall, TX 75087, United States

1-214-206-5231

https://maps.app.goo.gl/iYdGkyhiGAiUXN3G7