To replace a garage door seal, follow these steps from Blue Mound Garage Door:

  1. Measure the Door: Start by measuring the width and height of your garage door. This will help you determine the length of the new seal you’ll need to purchase.
  2. Purchase a Replacement Seal: Visit a local hardware store or garage door supplier to purchase a new garage door seal that matches the size and type of your existing seal. Look for a high-quality seal that is designed for your specific climate conditions and offers good durability.
  3. Gather Tools and Materials: Before you begin the replacement process, gather all the necessary tools and materials. You’ll typically need a utility knife, pliers, a ladder, a screwdriver, and the new garage door seal.
  4. Open the Garage Door: Open the garage door fully to provide easy access to the bottom seal. If needed, use a ladder to reach higher sections of the door.
  5. Remove the Old Seal: Examine the bottom of the garage door and locate the existing seal. Starting from one end, use a utility knife or pliers to carefully remove the old seal. Take note of how the seal is attached and any specific clips or fasteners used.
  6. Clean the Bottom of the Door: Once the old seal is removed, take some time to clean the bottom section of the garage door. Remove any dirt, debris, or adhesive residue to ensure a smooth surface for the new seal.
  7. Install the New Seal: Take the new garage door seal and align it with the bottom of the door. Start at one end and press the seal firmly against the bottom, ensuring it sits flush and evenly along the entire width of the door. Use a screwdriver or other suitable tool to secure the seal according to the manufacturer’s instructions. This may involve inserting clips, screws, or adhesive strips.
  8. Trim Excess Seal: Once the seal is securely in place, use a utility knife to carefully trim any excess length. Make clean, straight cuts to ensure a neat appearance.
  9. Test the Seal: Close the garage door and observe the newly installed seal. Make sure it forms a tight seal along the bottom of the door, preventing drafts, water, and pests from entering the garage. Open and close the door a few times to ensure the seal doesn’t interfere with the door’s movement.
  10. Make Adjustments if Necessary: If you encounter any issues with the seal’s fit or performance, make necessary adjustments. This might involve repositioning the seal or tightening any fasteners. Refer to the manufacturer’s instructions for troubleshooting and adjustments.

By following these steps from Blue Mound Garage Door, you should be able to successfully replace the garage door seal. However, keep in mind that the exact process may vary depending on the type and brand of the garage door seal you’re using. Always consult the manufacturer’s instructions for the most accurate and detailed guidance tailored to your specific seal.

Blue Mound Garage Door & Gate Company

1609 Tyson St #5, Blue Mound, TX 76131, United States

817-631-5688